Filter
Top Products
84-Inch Bed Extension 4 Part No. 53000M701
11. Attach bed ends to head and foot spring assemblies.
NOTE: If the bed has manually or motorized adjustable bed ends, use the extended drive shaft
supplied with this kit.
12. Replace the existing drive shaft with the extended drive shaft supplied with this kit.
13. Remove existing pull tube end in head motor assembly or head crank assembly and
replace with the pull tube end furnished with this kit.
14. Reconnect pull tube end to head spring drive arm using the clevis and cotter pins.
Refer to FIGURE 6.
15. Bed requires an 84-inch mattress.
NOTE: If assistance is required or any problems are encountered during the conversion, contact
customer service at 1-800-333-6900
FIGURE 6 - ATTACHING PULL TUBE END TO HEAD DRIVE ARM
Invacare Corporation www.invacare.com
USA Canada
One Invacare Way 570 Matheson Blvd E Unit 8 Invacare is a registered trademark of
Elyria, Ohio USA Mississauga Ontario Invacare Corporation.
44036-2125 L4Z 4G4 Canada Yes, you can. is a trademark of Invacare
800-333-6900 800-668-5324 Corporation.
©2004 Invacare Corporation
Part No. 53000M701 Rev F 06/04