Filter
Top Products
Part No. 1114831 5 Bolt-In-Place/Spring Button
Front Rigging Kit
NOTE: Swingaway
footrests shown.
Footplate
Assembly
Front Rigging Support
Cam
Lock
Lever
Riv Nut
Button
Head
Screw
NOTE: Swingaway
footrest shown.
Front Rigging Support
Footplate
Assembly
Cam Lock
Lever
Release
Button
Adjustment
Holes
Release Buttons
Top Spring Button
Release Buttons
Spring Button
Bottom Spring Button
Spring
Spring
Spring
FIGURE 2 - INSTALLING THE SPRING BUTTON FOOTPLATE KIT
DETAIL “A”
DETAIL “B”
ELEVATING LEGRESTS/
FOOTRESTS WITH
ADJUSTABLE ANGLE
FOOTPLATES
FOOTRESTS
SPRING BUTTON HEIGHT ADJUSTMENT (FIGURE 2)
NOTE: This procedure applies to the swingaway footrests and swingaway elevating legrest.
1. Remove the swingaway front rigging. Refer to INSTALLING/REMOVING THE
FRONT RIGGINGS in the owner’s manual shipped with wheelchair.
NOTE: Lay the front rigging assembly on a flat surface to simplify this procedure.
2. Pull the cam lock lever UP to UNLOCKED position.
NOTE: The elevating legrest has two (2) sets of release buttons, one (1) set above the other. Each
set will be visible one at a time allowing finer footplate height adjustment.
3. Push IN the release buttons and reposition the footplate assembly to the desired
height.
4. Ensure that the release buttons fully protrude from holes on both sides of the front
rigging support.
5. Rotate cam lock lever DOWN to LOCKED position.
6. Repeat this procedure for the other footplate, if necessary.
7. Reinstall the swingaway front rigging assembly. Refer to INSTALLING/REMOVING THE
FRONT RIGGING in the owner’s manual that shipped with wheelchair.
8. Ensure Release buttons are properly seated and FULLY protrude through the
adjustment holes before use.