Husqvarna DS50 Microscope & Magnifier User Manual


 
6 – English
SAFETY INSTRUCTIONS
General safety precautions
Please read the operator’s manual carefully and make
sure you understand the instructions before using the
machine.
Never use the machine if you are tired, if you have drunk
alcohol, or if you are taking medication that could affect
your vision, your judgement or your co-ordination.
Wear personal protective equipment. See instructions
under the heading Personal protective equipment.
Never use a machine that is faulty. Carry out the checks,
maintenance and service instructions described in this
manual. Some maintenance and service measures must
be carried out by trained and qualified specialists. See
instructions under the heading Maintenance.
Never allow anyone else to use the machine without first
ensuring that they have understood the contents of the
operator’s manual.
People and animals can distract you causing you to lose
control of the machine. For this reason, always remain
concentrated and focused on the task.
Be careful as clothing, long hair, and jewellery can get
caught in moving parts.
Transport and storage
Do not store or transport the stand with the drilling machine
fitted in order to protect your stand from damage.
Store the equipment in a lockable area so that it is out of
reach of children and unauthorised persons.
Store the drilling machine and stand in dry and frost free
conditions.
General working instructions
Basic safety rules
Do not use the machine in bad weather, such as dense
fog, rain, strong wind, intense cold, etc. Working in bad
weather is tiring and can lead to dangerous conditions,
e.g. slippery surfaces.
Never start to work with the power cutter before the
working area is clear and you have a firm foothold. Look
out for any obstacles with unexpected movement. Ensure
when cutting that no material can become loose and fall,
causing operating injury.
Ensure that the working area is sufficiently illuminated to
create a safe working environment.
Make sure that no pipes or electrical cables are routed in
the area to be drilled.
Always check the rear side of the surface where the drill
bit will emerge when drilling right through. Secure and
cordon off the area and make sure that no one can be
injured or material damaged.
Never work alone, always ensure there is another person
close at hand. Apart from being able to receive help to
assemble the machine, you can also get help if an
accident should occur.
Keep all parts in good working order and ensure that all
fixtures are properly tightened.
!
WARNING! There is always a risk of crush
injuries when working with products
containing moving parts. Wear protective
gloves to avoid body injuries.