Filter
Top Products
10 11
MEMORY RECALL
This thermometer will automatically store the last 10
measurements in memory. The most recent reading will
automatically display when the unit is turned on. Each new
temperature reading will also be entered into the memory as
the most recent record.
When in memory mode, an arrow in the upper left corner will
appear with the memory record number to the right as shown
in the illustration below.
Press “MEMORY” to cycle through the records from number 0
(the most recent reading) to number 9.
Note that when memory is at capacity, the oldest record will be
deleted to make room for a new reading.
Memory will be cleared as a result of battery removal or power
failure. A default reading of 00.0°F (00.0°C) will be displayed
when memory is cleared until a new temperature reading is taken.
HOW TO TAKE A TEMPERATURE READING
1.Always make sure that the waterproof probe has
been cleaned with a cotton swab moistened with
alcohol since its previous usage.
2.Press and release the “SCAN” button on the side of
the device. All display symbols will appear for
approximately one second (Figure 1).
3.When the ear thermometer is ready, the display will
next show the results from the last reading. The unit
is ready for measurement at this point (Figure 2).
Indicates memory
reading and number
Figure 1
Figure 2
Indicates a
memory
reading
TE-101.IB.v2 4/7/06 12:18 PM Page 11