Filter
Top Products
Setting The Zero Point
and Balance
Before using the scale for the first time or
when the scale has been moved to another
place, you must set the zero point and
balance the scale before weighing yourself.
Zero Point
1. With nothing on the PLATFORM, slide
the UPPER and LOWER sliding weights
to ZERO.
2. To set the POINTER TIP in the middle of
the OVAL you must use the ADJUSTING
SCREW.
A. Turn the ADJUSTING SCREW
counterclockwise towards “ – “
to raise the POINTER TIP.
B.Turn the ADJUSTING SCREW
clockwise towards “ + “
to lower the POINTER TIP.
5. Use SCREW DRIVER to hook POTHOOK
into the hole of the LONG ARM CONNECTION PLATE.
6. Use ALLEN KEY to remove pre-set A S S E M B LY SCREW (located on the
bottom of the base) to release the LONG ARM CONNECTION PLAT E
into place.
7. Use ALLEN KEY to attach POLE to BASE by inserting and turning
the 4 SCREWS tightly.
8. Slide POLE COVER down.
9. Replace PLATFORM by sliding it onto BASE and push down until it
snaps into place.
Long Arm
Connection Plate
Assembly
Screw
Screws
Upper Weight
Lower Weight
Adjusting Screw
Adjusting Screw Detail
Leveling Feet
Level
Leveling Foot
Locking
Dial
Platform Top
Side
Pointer Tip
Pothook
Step1
4
5
Step2
Balance
Place the scale on a flat, firm surface. Turn the 6 LEVELING FEET until the bubble inside
the LEVEL is directly in the middle of the circle. Use LOCKING DIAL to lock LEVELING FEET
into place.
SC-650-A.qxd 10/2/06 6:10 PM Page 5