Filter
Top Products
28
TROUBLESHOOTING
If any abnormality arises during use, please check the following points
Note: If the unit still does not work, contact HoMedics Consumer
Relations. Under no circumstance should you disassemble or
attempt to repair the unit by yourself. Contact information for
HoMedics Consumer Relations Department can be found on
the warranty page.
SYMPTOMS
POSSIBLE
CAUSES
CORRECTION
Unit does not turn on when
the START/STOP
button is pushed.
Batteries have
run down.
Replace them with
four new AA
alkaline batteries.
Battery polarities
have been positioned
incorrectly.
Re-insert the batteries in the
correct positions.
EE measurement error
symbol shown on display or
the blood pressure value is
displayed excessively low
(or high).
Cuff has been placed
incorrectly.
Wrap the cuff properly so
that it is positioned
correctly.
Did you talk or move
during measurement?
Measure again. Keep arm
steady during
measurement.
Shaking of the arm with the
cuff on.
Er error symbol shown on
display - measurement
result exceeds
measurement range.
Did you move during
measurement?
Shaking of the arm with
the cuff on.
Measure again. Do not
move during measurement.
E1 error symbol shown on
display
Air circuit abnormality. Cuff
tube may not be plugged
into monitor correctly.
Check cuff connection.
Measure again.
E2 error symbol shown on
display
Inflation pressure exceeding
300 mmHg.
Switch the unit off, then
measure again.
E3 error symbol shown on
display
Data error. Remove and reload the
batteries.