HoMedics BPA-060 Blood Pressure Monitor User Manual


 
INSTALLING BATTERIES
1. Press down on latch and lift the battery cover to open
the battery compartment.
2. Install or replace 4 “AA” sized batteries in the
battery compartment according to the indications
inside the compartment.
3. Close the battery cover by pushing in the top end
of the battery door.
Replace the batteries if:
1. The weak battery symbol appears on the display.
2
. Nothing appears on the display when the power is
switched on.
As the supplied batteries are for test only, they may be dis-
charged earlier than batteries you buy in stores. Replace
the batteries in pairs. Use only 1.5V AA alkaline batteries.
Remove batteries when unit is not in use for extended peri-
ods of time. Date and time will need to be reset if batteries
are removed or replaced.
Note: Batteries are hazardous waste. Do not dispose of
them together with the household garbage.
12
11
USING THE AC ADAPTER (NOT INCLUDED)
This monitor is designed for operation with batteries or an
o
ptional AC adapter. Please use only a compatible,
UL approved AC adapter with required voltage and current
as indicated in this manual. Contact HoMedics Consumer
Relations at 1-800-466-3342 to purchase a compatible AC
adapter.
Note: • Please unload the batteries when operating with
the AC adapter for an extended period of time.
Leaving the batteries in the compartment for a
long time may cause leakage, which may lead to
damage of the unit.
No batteries are needed when operating with
the AC adapter.
• Date and time will need to be reset if AC adapter
is unplugged.
1. Connect the AC adapter with the AC adapter jack in
the back of the unit as shown below.
2. Please use only the AC adapter included with
this monitor.
AC Adapter
Input: 100-240V~0.2A 50/60Hz
Output: 6V DC 500mA 3 W Max
Connect AC
adapter here
Battery
Cover