Filter
Top Products
8 After use, make sure to pull out the power adaptor from the electric outlet and the
main body.
(Fig. 7)
To continue to use the next mode, do not disconnect the power adaptor.
3 Choose "the strength" of electrical potential with the level switch button.
Switch the "strength" with the Level switch button according to the condition of your skin.
Every time the level indicator button is pressed, the high, medium, and low of the
electrical potential will be switched. There will be no change in vibration strength.
“Low” on the level indicator lamp lights and “
HOT MOISTURIZE
” on the mode
indicator lamp starts flashing. If a lamp in another mode is flashing, press the mode
switch button to switch to “
HOT MOISTURIZE
.”
2 After confirming that the power adaptor is connected to the main body, press the power
switch. (Fig.8)
When the "
HOT CLEANSING
" mode is finished, press the power switch and the
"
HOT MOISTURIZE
" mode will automatically be set.
7 After 3 minutes have elapsed, the device will automatically shut off.
(Auto shutoff function)
The finish sound (beep beep) will inform you.
Unless you apply cotton puff to your skin while touching the back plate, the device
will not vibrate. (skin sensing function)
If the heating head is not vibrating, the device is not working.
If you leave the device as it is for about 3 minutes without vibration, the device will
automatically switch "Off." (Automatic shutoff function)
CAUTION
Apply the cotton gently to the face and slowly move the device by sliding it from the
center of the face to the outer side.
Do not keep the cotton on the same area of skin, it is necessary to
move it around.
(Cause of problems with your skin or physical discomfort.)
Add more toner when there is no moisture in the cotton or when the device is
difficult to slide.
Do not apply the device on the same area of skin for more than 10 seconds.
If you feel your skin tingling by micro current while using the device, press the Level
switch button and switch to "Low."
If you still feel your skin tingling, use the device by adding more toner.
9 Remove the ring and the cotton.
Wipe off the surface of the head with a tissue.
Do not use the cotton again once it is used. It might cause problems with your skin.
When not using cotton
If you use a gel-like toner/moisturizing product (all-in-one type toner for moisturizing) or
thick toner which is difficult to permeate the cotton you can use this device without attaching
cotton to the body.
1 Apply a gel-like moisturizing product or thick toner that you would normally use onto the
heating head and smoothen it over the entire head with your fingers.
(Fig. 9)
It is recommended that when using the device for the first time or if you feel some
discomfort, use the device in "Low."
Moisturizing product