Filter
Top Products
4
For model 752KL, insert display module into wall
mount/table top adapter. For wall mount place
display module in adapter (see diagram 5a). For
table-top place display module in adapter (see
diagram 5b). Use 2 Phillips screws to secure the
adapter to the display module.
Diagram 5a
Diagram 5a
9.
10.
11.
For model 597KL, insert height rod into pillar
base slot (see diagram 6a). Feed screw into hole.
Use Flat-Head Screwdriver to tighten height rod
to scale from the back (see diagram 6b).
For models 597KL and models 599KL, attach the AC
adapter holder with 2 Phillips sheet metal screws.
Diagram 6a
Diagram 6b
12.
For AC operation – plug adapter into base of scale
and into power source, or use the DC IN plug on
the back of the display module.
13.
Remove protective plastic film from display
14.
Turn scale on by pressing the ON/OFF button. The
display will show “Health o meter ….. and then 000.0
NOTE:
if the set up procedure failed, refer to the troubleshooting instructions. If the problem is not corrected, refer to Health o meter® Professional technical
support at 1.800.638.3722
NO.
DESCRIPTION FUNCTION
1. ON/OFF Turns scale ON and OFF.
2. ZERO Zeros the scale prior to weighing.
3. HOLD/RELEASE Holds the value of the weighed object on the display until the button
is pressed again to clear the value.
4. KG/LB button Toggles between kilograms or pounds.
5. UP ARROW Scrolling method for entering height
6. BMI Prompts entry of data to calculate the patient’s Body Mass Index (BMI).
7. DOWN ARROW Scrolling method for entering height
8. CLEAR Functions as menu escape in BMI mode
9. ENTER Used to accept height in BMI mode
Operating Instructions
1. Press the ON/OFF button to turn the scale on.
2. Wait until ‘000.0’ and ‘Zero’ on the left side of the display appear
3. Ask the patient to step on the scale. The scale will display the patient’s weight. (Note: the weight will change until the patient is stable). Once the
patient is standing still, the scale will beep three times and the word Lock will appear on the display.
4. To use the BMI feature, place the patient on the scale platform; press the BMI button. The scale will prompt you to enter the patient’s height. Use the
arrow (scroll) keys to find the correct height (the default height is 5 ft. 6.0 in.). Press ENTER. Display will read the patient’s BMI.
Weight may remain displayed on the scale by pressing the HOLD/RELEASE button. To release, press the HOLD/RELEASE button again.
NOTE:
The scale will always default to the settings and units last used.
*
To change the scale default units to kilograms, or to deactivate the LB/KG button, please contact Technical Support at 1.800.638.3722.