Filter
Top Products
11
Power Supply Cable - Hoist Connection
The Power Supply Cable connects to the hoist via a 4-pin (4P) plug and socket or a direct fitting
depending on the product code. Make this connection as follows:
Refer to Figure 3-5 or 3-6 depending on the product code.
For ER2080S and ER2100L insert the 4P plug of the Power Supply Cable into the 4P Socket
on the hoist and hand tighten the Lock Ring.
For ER2100S, ER2150S, and ER2200S – The power supply cable should be pre-installed to
the switch box and properly connected.
Install the Cable Support Arm (pre-installed on the Power Supply Cable) on to the Socket
Holder or Switch Box depending on the product code. Use the pre-installed Machine Screws
and Lock Washers.
Use care to avoid twisting or kinking the Power Supply Cable.
Insert the 4P Plug into the 4P Socket on the hoist and hand-tighten the Lock Ring.
Figure 3-5 Pendant and Power Supply Cable Connections
for ER2080S and ER2100L