Filter
Top Products
Power Chair
Preparation
AL650
CHOOSING A LOCATION and
MOUNTING THE DOCKING DEVICE PLATE
Drive
wheel
AL 650 - MOUNTING CHAIR PLATE
DOCKING
DEVICE
PLATE
DO NOT ATTEMPT TO USE THIS AUTOMATIC LOCK DOWN DEVICE ON ANY
FOLDING, OR TAKE APART CHAIRS UNLESS RECOMMENDED BY HARMAR.
FIND APPROXIMATE
CENTER OF THE CHAIR
USE EXISTING HOLES WHEREVER POSSIBLE
IF TOO LITTLE OR NO HOLES EXIST,
HOLES WILL NEED TO BE DRILLED.
REMOVE BATTERIES, AND USE PLATE
AS TEMPLATE. DRILL AS REQUIRED.
ATTACH TO CHAIR USING SUPPLIED
HARDWARE:
4 - 1/4-20 x 1.00” HHCS
4 - 1/4-20 NYLOC NUT
( ATTACHED TO PLATE )
THE CLOSER THE PLATE IS
POSITIONED TO THE DRIVE
WHEELS, THE EASIER THE
CHAIR WILL BE TO ENGAGE
THE DOCKING STATION
( CENTER )
6
ONLY