Filter
Top Products
LOOK DOWN ENTRY
OF STATION
SHOULDER
BOLT HEAD
UNDERSIDE OF
LOCKING DEVICE
DRIVE CHAIR
ONTO PLATFORM
Docking Station
Height
AL650
CHANGE TO LONGER
SCREWS AS REQUIRED
( CHART ON PREVIOUS PAGE )
DOCKING STATION CAN BE ORIENTATED
FOR DRIVER’S SIDE ENTRY
BY ROTATING STATION 180 DEGREES, AND
USING SECOND SET OF HOLES
ADD SPACERS AS REQUIRED
ACCORDING TO CHAIR’S GROUND
CLEARANCE
( CHART ON PREVIOUS PAGE )
DO NOT ADD SPACERS TO CHAIR
REMOVE LOCKING STATION AND
INSERT APPROPRIATE NUMBER
OF SPACERS. RE-ATTACH TO
PLATFORM. CHANGE TO LONGER
SCREWS IF NECESSARY.
VERIFY THE HEAD OF THE SHOULDER BOLT IS
BELOW THE UNDERSIDE OF THE LOCKING DEVICE
UP TO A 1/4” OF SPACE IS ACCEPTABLE
PERFORM LOCKING TEST
BY ATTEMPTING TO BACK OFF
CHAIR, WHILE IN STATION IS IN
LOCKED POSITION
AL 650 - SETTING DOCK STATION HEIGHT
NUMBER & TYPE OF SPACERS
DEPENDS ON CHAIR’S GROUND
CLEARANCE. SEE CHART
ON PREVIOUS PAGE
1
4"
5
ONLY