Harbor Freight Tools 96451 Thermometer User Manual


  Open as PDF
of 7
 
Page 3SKU 96451 For technical questions, please call 1-800-444-3353.
Maintain labels and nameplates on the product. These carry important safety
information. If unreadable or missing, contact Harbor Freight Tools for a
replacement.
SAVE THESE INSTRUCTIONS.
SPECIFICATIONS
Measurement Range
-4° F to 968° F
(-20° C to 520° C)
Accuracy
± 4° F below 212° F
± 2% reading above 212° F
Response Time 500 mSec
Distance to Spot Size 8:1
Battery Requirements 9V
UNPACKING
When unpacking, check to make sure that the item is intact and undamaged. If any
parts are missing or broken, please call Harbor Freight Tools at the number shown on the
cover of this manual as soon as possible.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
Note: Do not expose this product to strong electromagnetic elds, such as those
generated by an arc welder, induction heater, etc. Allow the unit 30 minutes to
adjust, before use, when introduced to signicant temperature changes.
Remove the battery cover and insert a 9V battery into the unit, paying attention to
polarity. Replace battery cover.
Push the “Laser ON/OFF” button to activate unit.
Pull and hold down trigger to turn unit on. When the Trigger is released, the unit
will beep and display the last temperature measured for 15 seconds.
To locate a “hot spot” move laser up and down in an area to see temperature
variance.
Non-reective surfaces will yield a more accurate reading than reective
surfaces. Duct tape (not included) can be applied to reective surfaces in order
2.
1.
2.
3.
4.
5.
AVOID EXPOSURE – Laser light is emitted from this aperture.
DANGER
LASER LIGHT
AVOID DIRECT EYE EXPOSURE
Max. Output: <5 mW, Wavelength: 630-660 nm
CLASS IIIa LASER PRODUCT
This product complies with 21 CFR 1040.10 and 1040.11
CEN-TECH, 3491 Mission Oaks Blvd., Camarillo, CA, USA, 93011
WARNING
To prevent serious injury:
Do not use for medical purposes.
Wear ANSI-approved safety goggles when replacing battery.
1.
2.
Date:_____, _________________DO NOT REMOVE.
REV 07j
 previous next