Filter
Top Products
SKU 95069 For technical questions please call 1-800-444-3353. Page 7
Unpacking
When unpacking your 70 Lb. Digital Scale, check to make sure that all parts listed in the parts list on
page 9 are included. If any parts are missing or broken, please call HARBOR FREIGHT TOOLS at
1-800-444-3353. It is important that you read the entire manual to become familiar with the product
BEFORE you operate and use the Digital Scale.
Assembly
Your Digital Scale comes completely assembled. Only maintenance such as battery replacement
may be required.
Operation
This product can be powered by an adapter or used with a 9V battery as the power source.
Using the Adapter
1. Plug the Charger Plug (30) into the Jack (24) located on the Scale. Plug the Charger Plug
into a 120V electrical outlet.
2. When done using the Scale, unplug the Charger Plug (30) from the Digital Scale. Unplug the
Charger Plug from the electrical outlet.
Changing the Battery
1. Batteries must be replaced if a picture of a battery is displayed in the LCD window.
Gently push in on the tab on the Battery Cover (27) and pull the Battery Cover (27) up-see
Figure 1.
2. Unplug the battery connecton from the Battery (26). Replace the dead Battery (26) with
a new 9V Battery. Snap the battery connection back onto the top of the Battery.
Battery
Cover (27)
Battery (26)
battery
compartment
Figure 1
Using the Scale
1. Press the Mode Key (see Figure 2) to set the Scale to the desired unit of weight, pounds or
Kilograms.
2. The Scale has a Backstop (1) located on top of the Scale. Lift the Backstop (1). Set the
item to be weighed against the Backstop (1). Failure to lift the Backstop (1) may
keep the Scale from operating properly.
3. Set the Scale on a level surface free from vibration and clear of electronic interference such
as radios, phones and microwaves.
4. Press the On/Off Button to turn ON the Scale-see Figure 2.