Hamilton Beach Easy Touch Iron Styling Iron User Manual


 
2
SAVE THESE INSTRUCTIONS!
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING
1. Use iron only for its intended use.
2. Verify that the voltage in your home corresponds to that of your
appliance.
3. To protect against risk of electric shock, do not immerse the iron in
water or other liquids.
4. The iron should always be turned to OFF before plugging or
unplugging from outlet. Never yank cord to disconnect from
outlet; instead, grasp plug and pull to disconnect.
5. Do not allow cord to touch hot surfaces. Let iron cool completely
before putting away. Loop cord loosely around iron when storing.
6. Always disconnect iron from electrical outlet when filling with
water or emptying and when not in use.
7. Do not operate iron with a damaged cord or if the iron has been
dropped or damaged. To avoid the risk of electric shock, do not
disassemble the iron. Call our toll-free customer service number
for information on examination and repair. Incorrect reassembly
can cause a risk of electric shock when the iron is used.
8. Close supervision is necessary for any appliance being used by or
near children. Do not leave iron unattended while connected
or on an ironing board.
9. Burns can occur from touching hot metal parts, hot water, or
steam. Use caution when you turn a steam iron upside down –
there may be hot water in the reservoir.
SPECIAL INSTRUCTIONS
1. To avoid a circuit overload, do not operate another high wattage
appliance on the same circuit.
2. If an extension cord is absolutely necessary, a 15-ampere cord
should be used. Cords rated for less amperage may overheat. Care
should be taken to arrange the cord so that it cannot be pulled or
tripped over.
When using your flatiron, basic safety precautions should always be followed, including the following:
OTHER CONSUMER SAFETY INFORMATION
This product is intended for household use only.
WARNING! Shock Hazard: This appliance has a polarized plug (one
wide blade) that reduces the risk of electric shock. The plug fits only
one way into a polarized outlet. Do not defeat the safety purpose of
the plug by modifying the plug in any way or using an adaptor. If the
plug does not fit, reverse the plug. If it still does not fit, have an elec-
trician replace the outlet.
Use the iron on an ironing board. Ironing on any other surface may
damage that surface.
Do not iron or vertical steam clothes that are being worn.
Do not use vertical steam in the direction of people or pets.
• Steam vents should be cleaned before first use. Prepare iron for
steam ironing, then iron over an old cloth for a few minutes while
letting the iron steam. This will clean the vents.
• Many irons spit or sputter during the first few uses with tap water.
This happens as the steam chamber becomes conditioned.
This will stop after a few uses.
• During first use of the iron, it may appear to smoke. This will stop
and does not indicate a defect or hazard.
READ BEFORE FIRST USE
840172600 ENnv05.qxd 7/15/08 11:28 AM Page 2