Filter
Top Products
16
ENGLISH
OPERATION
__________________________
7
Keep the strands of hair smooth to
avoid ridges.
6 Repeat this procedure with steps
2 to 5.
7 After using the appliance, switch
off the appliance using switch
B
and disconnect the power cord
from the mains.
– Power on indicator light
C
disappears.
Note
7
Allow the hair styler to cool down
fully before storing.
Styling waves or curls
1 Plug appliance into a suitable
mains supply.
2 Switch the hair styler on using the
On/Off switch
B
.
– The power on indicator light
C
illuminates.
Note
7
Make sure your hair is completely
dry.
3 Comb or brush out a section of
hair approximately 3 cm in width,
starting at the neck.
4 Place the section of hair between
the plates
A
, as near to the hair
line as you can, and then close
them.
5 Depending on the hair style, rotate
the appliance so that the hair
wraps around it at the height of
the plates
A
.
6 Slowly pull the appliance towards
the ends of the hair.
–
A curl is formed once the ap-
pliance has been pulled down
and over the ends of the hair.
7 Repeat this procedure section by
section.
8 After using the appliance, switch
off the appliance using switch
B
and disconnect the power cord
from the mains.
– Power on indicator light
C
disappears.
Note
7
Allow the hair styler to cool down
fully before storing.
Hints and tips
7
Hair should be completely dry to
achieve the best results.
7
Keep the strands of hair smooth
whilst you work, to avoid ridges
part way down the strand.
7
As with all hair stylers that reach
high salon temperatures, do not
use the appliance frequently to
avoid damage to hair.