Filter
Top Products
Labtron Digital Blood Pressure Monitor 8
Labtron Digital Blood Pressure Monitor 13
7. Attach the cuff: Hold the area of the cuff where the
hose exits the cuff rmly against the inside of the
bare upper arm directly over the brachial artery,
and the bottom of the cuff approximately one inch
(2-3cm) above the elbow, as shown in the third pic-
ture at right. Never place the cuff over clothing.
Pull the opposite end of the cuff snugly around the
arm and secure with the Velcro® fastener. The cuff
should be snug, but not too tight. If one or two n-
gers can t between the cuff and the arm, the cuff
is properly secured. If you are unable to t the cuff
as described above, a smaller or larger cuff should
be used.
1 inch
MAINTENANCE
Recommended care and maintenance:
Do not drop or pull excessively on monitor components or subject them to strong impact.
Do not use monitor close to any device with a strong electrical eld such as television,
microwave oven, X-Ray equipment, etc.
Never inate cuff above 300mmHg. Never inate cuff unless it is positioned on an arm.
Do not expose the monitor components to direct sunlight, high temperature, or high humidity.
Do not put any part of monitor in contact with sharp objects which could pierce the material
and cause damage.
Do not dismantle or disassemble monitor components.
Cleaning Wipe off all components with a clean, dry cloth. Do not use solvents or other
petroleum-based cleaners. Do not press cuff with a hot iron.
Storage Always deate the cuff completely before storage.
Remove the batteries when the device is to be stored for extended periods of
time. Note: Removing the batteries will erase all readings in memory.
707A-INS-LAB-RevC08-book.indd 8 1/3/08 11:36:36 AM