Filter
Top Products
3093062
Installation
1. Relieve the pressure as explained in the TRITON
Operation manual 309305.
2. Disconnect the air supply line from the bleed-type
master air valve (A). See the parts drawing on
page 3.
3. Remove the plug from the agitator port in the pail
cover.
4. Install the mounting collar (5) in the port so the
setscrew hole faces outward. Secure the collar
with the collar nut (6).
5. Remove the nut and agitator blade. Lower the
agitator (1) through the mounting collar as shown.
Reattach the blade and nut.
6. Install the setscrew (7) in the mounting collar (5)
and tighten it against the agitator shaft.
7. Screw the 1/8 npt elbow (2) into the air inlet port of
the agitator’s speed control.
8. Screw the tee (4) into the bleed-type master air
valve (A).
9. Screw the 1/4 npt elbow (3) into the branch of the
tee (4).
10. Connect the 1/4 in. (6.3 mm) OD tubing (8) be-
tween the two elbows (2, 3). Make sure the tubing
is securely fastened.
11. Ground the agitator as explained in the agitator
manual 306565.
12. Connect the air supply line to the tee (4).
13. Refer to the agitator manual 306565 for agitator
operating instructions, service, and parts informa-
tion.