Filter
Top Products
Compass Owner’s Manual – Models GP600 SS, GP600 CC Revised 052313
14
Seat Height & Angle
Adjustment Pins
ASSEMBLY
SEAT REMOVAL/INSTALLATION
The standard (18x18) seat assembly weighs about 49 pounds.
Please ask for help if you do not feel capable of safely lifting that much weight.
Removal of arms will significantly reduce the weight of seat.
Be sure the seat is correctly installed and locked before operating
your power chair.
Never pull on the arms or use them as a handle to move the power
chair as they could inadvertently pull out of the receiver bar causing injury.
REMOVAL
1. Disconnect the controller cable from the joystick. “Unclip” from arm and remove
Velcro tie-wraps. See figure 2 on page 13.
2. Lift the front and rear seat lock handles and slide the seat until all (4) of the seat
guides are out of the receivers.
INSTALLATION
The seat can be installed from either side of the power chair.
1. To install the seat, align the seat guides (front and rear) with the seat receivers
(front and rear).
2. Slide the seat towards the center of the power chair until the seat locks securely
in place. The front and rear locks must engage.
3. Reconnect the controller cable to the joystick cable.
Figure 3 Figure 4
Figure 5 Figure 6
Front Seat
Lock Handle
Rear Seat
Lock Handle
Front Seat
Lock Handle
Rear Seat
Lock Handle
Seat Locking
Handle
Seat Receiver
Seat Guides