Filter
Top Products
Black 0002
Black0002
INSTALLING TRANSMITTERS (FROM FRONT PANEL) INSTALLING TRANSMITTERS (FROM INSIDE CONSOLE) TESTING TRANSMITTERS
ERASING TRANSMITTERS CONNECTING TO RA-2400 FOR LOCAL CABLE PROGRAMMING TELEPHONE CONNECTIONS
SYSTEM OPERATION SUPERVISORY CONDITIONS ACTIVITY TIMER
AUDIO BOARD OPERATION SPECIFICATIONS
CODING FORMATS
DX CODE 24-BIT A1D PPM 1,048,567 CODES
DXS CODE 24-BIT A1D PPM 1,048,567 CODES
POWER REQUIREMENTS
PRIMARY SUPPLY 16 VAC 1.25 AMP PLUG-IN TRANSFORMER
BACKUP SUPPLY 12 VOLT 1.2 AMP/HOUR BATTERY
NORMAL OPERATING CURRENT 80 mA
ALARM OPERATING CURRENT 120 mA
BACKUP OPERATION DURATION 12 HOURS MINUMUM
BATTERY LIFE EXPECTED 3 YEARS
RF CHARACTERISTICS
RECEIVER TYPE DUAL-DIVERSITY SUPERHETERODYNE
RF SENSITIVITY -100 dBm TYPICAL
RADIO FREQUENCY 315 Mhz
MAXIMUM RANGE 400 FEET LINE-OF-SIGHT, OPEN RANGE
UL LISTED FOR 150’
COMMUNICATOR
COMMUNICATOR FORMATS 4 BY 2 (GENERAL OR POINT-TO-POINT), ADEMCO
CONTACT ID
UL TESTED WITH SURGARD SGMLRG-DG CENTRAL
STATION RECEIVER
DIALING TONE OR PULSE
DIALING DELAY 0 OR 15 SECONDS
REMOTE ACCESS PASSWORD 6 DIGITS
ACCOUNT NUMBER LENGTH 4 DIGITS
PRIMARY TELEPHONE NUMBER 20 DIGITS
SECONDARY TELEPHONE NUMBER 20 DIGITS
SUPERVISORY TELEPHONE NUMBER 20 DIGITS
CONSOLE STATUS REPORT OPTIONAL 1, 7 OR 30 DAY REPORT
CONSOLE
OPERATING TEMPERATURE 32°-100° F (0-50° C)
EMERGENCY ALARM DURATION 1-30 MINUTES
ACTIVITY TIMER PERIOD 8, 12, OR 24 HOURS
AUDIO LISTEN-ONLY, 2-WAY MANUAL, 2-WAY DUPLEX
RELAY OUTPUT N.O./N.C. (FORM C) @ 24 VOLT AC/DC 1 AMP
MAXIMUM, NEC CLASS II CIRCUITRY
IMPORTANT !!!
Linear radio controls provide a reliable communications link and fill an important need in portable
wireless signaling. However, there are some limitations which must be observed.
•
For U.S. installations only: The radios are required to comply with FCC Rules and Regulations
as Part 15 devices. As such, they have limited transmitter power and therefore limited range.
•
A receiver cannot respond to more than one transmitted signal at a time and may be blocked by
radio signals that occur on or near their operating frequencies, regardless of code settings.
•
Changes or modifications to the device may void FCC compliance.
•
Infrequently used radio links should be tested regularly to protect against undetected interference
or fault.
•
A general knowledge of radio and its vagaries should be gained prior to acting as a wholesale
distributor or dealer, and these facts should be communicated to the ultimate users.
INSTALL WITH
JUMPER SET
FOR INSTANT
ACTIVATES
AS ACTIVITY
NOTE: FOR DXS-31 STATIONARY TRANSMITTERS
INSTALL WITH
JUMPER SET
FOR DELAY
ACTIVATES
AS EMERGENCY
INSTALL
WITH
RIGHT
BUTTON
ACTIVATE
WITH
BOTH
BUTTONS
NOTE: FOR ALL TWO-BUTTON TX'S EXCEPT DXS-63
INSTALL
WITH
LEFT
BUTTON
ACTIVATE
WITH
EITHER
BUTTON
ADDS ONE TRANSMITTER AT A TIME
PRESS CLEAR BUTTON
FOR 5 SECONDS
5 BEEPS SOUND
(TX ADD MODE)
1
2
ACTIVATE TRANSMITTER
1 BEEP SOUNDS
(TX ADDED)
CONSOLE REVERTS
TO OPERATE MODE
NOTE: IF THE CONSOLE'S MEMORY
IS FULL, ONE LONG BEEP SOUNDS WHEN
TRYING TO ADD A TRANSMITTER
3
REPEAT STEPS 1 & 2
FOR ADITIONAL
TRANSMITTERS
(UP TO 16 TOTAL)
NOTE: PRESS CLEAR BEFORE
TRANSMITTING TO RETURN
TO OPERATE MODE WITHOUT ENTERING
A TRANSMITTER (2 BEEPS SOUND WITH
ACTIVITY TIMER ENABLED, 3 BEEPS
SOUND WITH ACTIVITY TIMER DISABLED)
THE CONSOLE WILL RESUME OPERATE
MODE AUTOMATICALLY AFTER
30 SECONDS
DXS-32: CUT JUMPER (INSTANT TX) FOR USE AS AN
ACTIVITY TX. SEE DXS-32 INSTALLATION INSTRUCTIONS
ADDS MULTIPLE TRANSMITTERS
PRESS TEST BUTTON
4 BEEPS SOUND
(TEST MODE)
3
2
ACTIVATE TRANSMITTER
1 BEEP SOUNDS
(TX ADDED)
REPEAT STEPS 2 & 3 FOR
ADDITIONAL TRANSMITTERS
(UP TO 16 TOTAL)
1
PRESS TEST BUTTON
AGAIN 5 BEEPS SOUND
(TX ADD MODE)
4
NOTE: IF THE CONSOLE'S MEMORY
IS FULL, ONE LONG BEEP SOUNDS
WHEN TRYING TO ADD A TRANSMITTER
PRESS CLEAR TO RETURN
TO OPERATE MODE (2 BEEPS SOUND
WITH ACTIVITY TIMER ENABLED, 3 BEEPS
SOUND WITH ACTIVITY TIMER DISABLED)
OTHERWISE, THE CONSOLE WILL RESUME OPERATE
MODE AUTOMATICALLY AFTER 3 MINUTES
5
3
2
1
PRESS TEST BUTTON
4 BEEPS SOUND
(TEST MODE)
ACTIVATE EACH OF
THE CONSOLE'S
TRANSMITTERS,
ONE AT A TIME
COUNT THE NUMBER
OF BEEPS THAT THE
CONSOLE SOUNDS
WHEN THE TRANSMITTER
IS ACTIVATED
NOTE: WITH THE MODEL VB-4 VOICE BOARD
INSTALLED, THE CONSOLE WILL ANNOUNCE
THE TRANSMITTER STATUS
PRESS CLEAR TO RETURN TO
OPERATE MODE (2 BEEPS SOUND
WITH ACTIVITY TIMER ENABLED,
3 BEEPS SOUNDS WITH ACTIVITY TIMER
DISABLED) OTHERWISE, THE CONSOLE WILL RESUME
OPERATE MODE AUTOMATICALLY AFTER 3 MINUTES
4
1-BEEP = TX OK
2-BEEPS = TX HAD ALARM
3-BEEPS = TX MISSED STATUS
4-BEEPS = TX HAS LOW BATTERY
PRESS AND HOLD TEST
BUTTON FOR 5 SECONDS
6 BEEPS SOUND
(ALL TRANSMITTERS
WERE ERASED)
1
NOTE: ALL TRANSMITTERS WILL BE ERASED!
PRESS CLEAR TO RETURN TO OPERATE
MODE (2 BEEPS SOUND WITH ACTIVITY
TIMER ENABLED, 3 BEEPS SOUND WITH
ACTIVITY TIMER DISABLED) THE CONSOLE
WILL RESUME OPERATE MODE AUTOMATICALLY
AFTER 3 MINUTES
2
PRESS TEST BUTTON
MOMENTARILY, 4 BEEPS
SOUND (TEST MODE)
NOTE: CONSOLE WILL EXIT TEST MODE
AUTOMATICALLY AFTER 3 MINUTES
OR BY PRESSING THE CLEAR BUTTON
2
3
WHEN RA-2400 CONNECTION TIMER
STARTS COUNTING DOWN, PRESS
THE EMERGENCY BUTTON
4 BEEPS SOUND (RA-2400 ANSWER)
1
TO LOCALLY PROGRAM
THE CONSOLE, CONNECT
THE MODEM'S LINE JACK
TO THE CONSOLE'S LINE
JACK
4
PERFORM THE STEPS DETAILED IN THE
RA-2400/PERS-2400 REFERENCE GUIDE (P/N 217163)
TO SET UP THE RA-2400 PROGRAM
LINE-TO-LINE
5
PERFORM PROGRAMMING IN
THE RA-2400 SOFTWARE, THEN
DISCONNECT FROM THE CONSOLE
CONSOLE
STANDING BY
CONSOLE
IN ALARM
POWER LIGHT IS ON
OTHER LIGHTS ARE OFF
- IN CASE OF EMERGENCY -
PRESS AND
MOMENTIARLY
HOLD
EMERGENCY
BUTTON
- OR -
ACTIVATE
EMERGENCY
TRANSMITTER
SIREN SOUNDS
UNTIL CLEAR BUTTON
IS PRESSED,
CENTRAL STATION
REPORT IS COMPLETE,
OR SIREN TIME EXPIRES
PRESS CLEAR TO
STOP SIREN
(ADDS CANCEL TO
ALARM REPORT IN
PROGRESS)
SENDING LIGHT
FLASHES DURING
COMMUNICATION
PRESS TRANSMITTER
BUTTON FOR AT LEAST
2 SECONDS
TRANSMITTER LOW BATTERY TROUBLE
TRANSMITTER SUPERVISORY TROUBLE
NOTE: THE CONSOLE WILL ANNOUNCE
THE SUPERVISORY CONDITIONS WITH
THE OPTIONAL MODEL VB-4 VOICE
BOARD INSTALLED. THE VOICE CAN
BE DISABLED THROUGH
PROGRAMMING
WHEN A TRANSMITTER SENDS A LOW BATTERY SIGNAL THE
CONSOLE'S TROUBLE INDICATOR WILL BLINK SLOWLY.
IF A TRANSMITTER PROGRAMMED AS SUPERVISED FAILS
TO REPORT STATUS IN A 24 HOUR PERIOD, THE CONSOLE'S
TROUBLE INDICATOR WILL LIGHT.
CONSOLE BACKUP BATTERY TROUBLE
THE CONSOLE WILL TEST ITS BACKUP BATTERY EVERY 8 HOURS.
IF THE BATTERY TESTS LOW, THE POWER INDICATOR WILL BLINK
SLOWLY WHILE THE CONSOLE CHARGES THE BATTERY.
CLEARING TROUBLE INDICATIONS
PRESS THE CLEAR BUTTON TO STOP TROUBLE
INDICATORS AND SOUNDERS
THE CONSOLE WILL REPORT
TROUBLE AND/OR 30-DAY STATUS
TO THE CENTRAL STATION IF
ENABLED IN THE COMMUNICATOR
PROGRAMMING
NOTE: THE TROUBLE CONDITION WILL LIKELY OCCUR AGAIN UNTIL THE PROBLEM IS FIXED
WHEN TROUBLE EXISTS,
THE CONSOLE WILL BEEP EVERY
HOUR UNTIL CLEARED:
2-BEEPS = CONSOLE LOW BATTERY
3-BEEPS = TRANSMITTER SUPERVISORY
4-BEEPS = TRANSMITTER LOW BATTERY
3
TIME RUNNING OUT
2
1
ENABLING THE ACTIVITY TIMER
PRESS THE HOME BUTTON FOR 5 SECONDS
TO TURN THE ACTIVITY TIMER ON
THE HOME INDICATOR WILL LIGHT, SHOWING
THAT THE ACTIVITY TIMER IS ENABLED
ACTIVITY TIMER RUNNING
NOTE: TO TURN THE ACTIVITY
TIMER OFF, PRESS THE HOME BUTTON
FOR FIVE SECONDS
THE SUBSCRIBER NEEDS TO PRESS
THE HOME BUTTON OR TRIGGER AN
ACTIVITY TRANSMITTER BEFORE THE
TIMER EXPIRES TO PREVENT
AN INACTIVITY REPORT
PRESSING THE HOME BUTTON
RESTARTS THE TIMER
RESETING ACTIVITY TIMER
NOTE: THE ACTIVITY TIMER CAN
BE ENABLED FOR 8, 12, OR 24 HOURS,
OR DISABLED BY PROGRAMMING
4
THE HOME INDICATOR WILL BLINK & A SHORT
BEEP SOUNDS EVERY 10 SECONDS WHEN
LESS THAN 15 MINUTES OF TIME REMAIN
PRESS "9" TO DISCONNECT THE CALL
PRESS "3" TO LISTEN
PRESS "1" TO TALK
ALL
AUDIO
MODES
2-WAY MANUAL
AUDIO MODE
THE "1" AND "3" KEYS ARE NOT USED IN LISTEN-ONLY AUDIO MODE
THE "1" AND "3" KEYS CAN BE USED IN FULL DUPLEX MODE,
ALTHOUGH THE MODULE WILL SWITCH TO 2-WAY MANUAL
MODE. PRESS "8" TO RETURN TO DUPLEX MODE.
PRESSING ANY KEY OTHER THAN "9" WILL EXTEND THE AUDIO TIME 90 MORE SECONDS
NOTE: TO USE THE AUDIO FEATURES
THE MODEL VB-4 AUDIO MODULE
MUST BE INSTALLED IN THE CONSOLE
CENTRAL STATION OPERATOR:
USE THESE KEYS ON A TELEPHONE SET
CONNECTED TO THE COMMUNICATOR LINE
TO CONTROL THE AUDIO MODULE
3
• LISTEN-ONLY
• 2-WAY MANUAL
• 2-WAY FULL DUPLEX
PROGRAM THE CONSOLE FOR
THE DESIRED AUDIO MODE
2
1
AFTER THE CENTRAL STATION
OPERATOR ACKNOWLEDGES
THE COMMUNICATOR'S REPORT,
THE CONSOLE WILL STOP ITS
SIREN AND SWITCH TO THE
AUDIO MODE FOR 90 SECONDS
CONNECT TELEPHONE
LINE TO THIS JACK
CONNECT LOCAL
TELEPHONE TO
THIS JACK
TELEPHONE
JACK
LOCAL
TELEPHONE
ROUTE CABLES UNDER
STRAIN-RELIEF TABS
PERS-2400
CONSOLE WITH
REAR COVER
INSTALLED