Filter
Top Products
ESSICK EM-700S & 700P — PARTS & OPERATION MANUAL — REV. #8 (03/17/08) — PAGE 9
EM-700S & 700P — OPERATIONS
PADDLE SHAFT BEARING
The paddle shaft in the Essick Mixer rotates in sealed ball
bearings requiring no additional lubrication.
BEARING BRACKET
Grease the bearing bracket every month.
COUNTERSHAFT
The countershaft rotates on two self-aligned pillow block
bearings. Grease these every 40 hours using grade #1 Lithium
Base grease.
GEAR ALIGNMENT
The countershaft and driven pinion are mounted on a slotted
base. To align gears, loosen pillow block mounting bolts and
move them until the necessary alignment has been made.
GEAR LUBRICATION
The surface of the pinion and the bull gear should be very
lightly greased every 250 hours.
IMPORTANT! AVOID OVER-GREASING.
EXCESS GREASE WILL ACCUMULATE
CONTAMINATES AND CAUSE
PREMATURE WEAR.
IMPORTANT — DRUM HEAD SEAL CARE
On each end of the mixing drum is a drum head containing self
adjusting paddle shaft seals. These seals consist of packing
rings, split glands and spring actuated adjusters. A properly
maintained seal prevents material from working around the
paddle shaft, causing excessive wear. The following is a
suggested procedure of maintenance for protection of the
paddle shaft and bearings:
A. Keep the drum head clean of plaster built up, so the spring
adjusters will be free to work.
B. Replace with one new ring of packing and waterproof grease
when split gland or pressure plate is about to bottom out against
the end of the drum.
New Packing
When the old packing is to be completely replaced, coat shaft
and packing generously with a good grade of waterproof
grease and insert packing rings. Tighten the two spring
adjuster nuts on each end until the spring is compressed to
1¾ inches or the top of the adjusting nut is even with the top of
the drum head.
Also, whenever the paddle shaft is removed, new waterproof
grease should be packed around the ball bearings in the drum
heads before reinstalling the shaft. Fill the cavity completely.
DRUM GRILL
The drum opening is covered by a steel grill that is hinged for
easy cleaning. This grill should be closed at all times when
mixer is in use. Do not remove the grill or grill opening bar.
Keep the grill clean by washing it down daily.
CAUTION: Stop the engine before allowing anybody to put