Escali C6630 Scale User Manual


  Open as PDF
of 7
 
6
UPPER AND LOWER QUANTITY LIMIT SETTING
1. Turn the scale on.
2. Press “PRESET QTY” key, the 3 LCD will show as below.
3. Input the upper limit quantity in the “UNIT WEIGHT” display. Then press “M+” key to
confirm.
4. Input the lower limit quantity in the “TOTAL (PCS)” display. Then press “M+” key to
confirm.
5. Place the samples on the scale platform. When the quantity arrives at the upper limit,
the scale will alarm with a beep sound. The “WEIGHT” display will show the weight,
the “UNIT WEIGHT” display will show .
6. If the quantity of the sample is below the lower limit, scale will alarm with beep, beep
sound. The “WEIGHT” display will show the weight, the “UNIT WEIGHT” display will
show .
7. The upper & Lower quantity limit can be cancelled by pressing the “CANCEL
PRESET
” key.
USING THE TARE MODE:
1. Turn the scale on.
2. “0.000” will be shown on the “Weight” display after a few seconds.
3. Place an item on the weighing platform and read the value accordingly.
4. Press the “TARE” key, the weight of this item will be eliminated and the reading will
change to “0.000”.
5. Place next item on the weighing platform and get the reading.
Note: The scale will display a negative reading when you remove all items. Press the
“TARE” or “ZERO” key once and the negative reading will disappear.
OVERLOAD
When the loading capacity exceeds the maximum capacity of the Digital Scale, the word
“O_Ld” will be displayed on the “Weight” LCD screen. Remove the item(s) from the scale
platform to avoid damage to the scale.
EL BACK-LIGHT
The EL Back-light will automatically light up when the scale is in operation. It will turn-off
automatically when the scale is idle..
POWER OFF
The scale can be powered off manually by pressing the “On/Off” switch.
 previous