Filter
Top Products
- 21 -
• Storing, calling up and deleting the readings:
a. Storing the data:
After every blood pressure measurement the data of the systolic, diastolic and pulse rate
are stored automatically. The memory can store the latest 48 readings. If there are more
than 48 readings, the oldest ones are deleted automatically.
b. Recalling data:
(1) On pressing the RECALL button, there are no data on display, if no data have been
stored. If data are stored, the display shows the last measured readings for the
systolic, diastolic and heart beat rates and go off after one minute (60 seconds).
(2) To read the next line of the stored readings, press the button RECALL. The readings
recalled in the display are numbered appropriately. After reading the stored readings,
which appear in the cycle of 48 readings.
(3) To cancel reading during the display of the readings, the START/ STOP button must
be pressed.
c. Deleting data
(1) Remove the batteries and then re-insert the 2 batteries.
(2) To check if the data are deleted, press RECALL button. If so, the display will not show
any data.
• Changing the batteries
If “ “ appears in the display, the battery is consumed.
Replace the batteries otherwise no further blood pressure measurements are possible.
MAINTENANCE
• To clean the housing, use a lightly moistened cloth with a little cleaning medium and then dry
it with a dry piece of cloth. Use dry cloth to clean the sleeve if it is dirty.
• Do not use any spray cleaners or strong cleaning media.
• If the unit is not going to be used for some time, remove the batteries. (*Expired batteries can
damage the unit.)
GB
GB
BM101 10/16/06 12:15 PM Page 21