Filter
Top Products
© 2013 Elo Touch Solutions, Inc. All rights reserved.
User Manual 2401LM
SW200127 Rev A - Page 17 of 32
Chapter 3: Mounting
General Mounting Information
The OSD text can be rotated through the OSD menu to better suit your mounting orientation.
The holes located on the top and bottom of the Touchmonitor case are for ventilation. Do not block,
cover, or insert anything inside the ventilation slots.
Rear VESA Mount
A four-hole 100x100mm mounting pattern for M4 screws is provided on the rear of the monitor.
Remove the stand using a Phillips screwdriver to access this mounting interface. The VESA
FDMI-compliant mounting is coded: VESA MIS-D, 100, C