Filter
Top Products
GF0700137RevA07, September 2007 • Paramount XD Owner’s Manual 19
Adjust elevating legrest panel position
The legrest panel has three
mounting positions one inch
apart on legrest tube. Refer
to picture at right. To adjust:
1. Rotate legrest panel /
hinge plate assembly
on legrest tube so that
legrest tube stop is in
center of hinge plate
slot.
2. Slide legrest panel /
hinge plate assembly up
or down on legrest tube
to desired position.
3. Rotate legrest panel / hinge plate assembly on legrest tube so
that legrest tube stop is aligned in desired position.
WARNING: Ensure that legrest panels are locked in place
before occupying or operating wheelchair.
CROSSBRACES
Tighten crossbraces
M13 wrench, M6 hex key
Check the crossbraces to ensure that the bolt and nut securing both
crossbraces in the center of the wheelchair are secure (crossbraces
should be loose enough to fold easily, yet snug enough to take up
excess play). Use a M13 wrench and M6 hex key to tighten.
elevating
legrest
legrest tube stop
legrest panel /
hinge plate
assembly
Adjust legrest panel position