Filter
Top Products
EDGE 540. Instruction Manual.
9
4) Using a 1mm drill bit and the control
horns as a guide, drill the mounting holes
through the aileron halves.
5) Mount the control horns by inserting the
screws through the control horn bases and
aileron halves, then into the mounting
backplates. Do not overtighten the screws or
the backplates may crush the wood.
2) Locate the two nylon control horns, two
nylon control horn backplates and two ma-
chine screws.
Control Horn.
Mounting Screws.
Mounting Plate.
3) Position the aileron horn on the bottom
side of aileron. The clevis attachment holes
should be positioned over the hinge line.
6) Thread one nylon adjustable control horn
onto each aileron control rod. Thread the
horns on until they are flush with the ends of
the control rods.
7) Pushrod assemble as same as pictures
below:
2mm x 30 mm.
2.8cm.
Pushrod.
Servo arm.
Straigh line.
M3 lock nut.