KNOW EVERYTHING ABOUT THE INFINITI HAIR DESIGNER
™
BY CONAIR
®
KNOW EVERYTHING ABOUT THE INFINITI HAIR DESIGNER
™
BY CONAIR
®
KNOW EVERYTHING ABOUT THE INFINITI HAIR DESIGNER
™
BY CONAIR
®
KNOW EVERYTHING ABOUT THE INFINITI HAIR DESIGNER
™
BY CONAIR
®
10. Do not use an extension cord to operate dryer.
11. Do not direct hot air toward eyes or other heat-sensitive areas.
12. Attachments may be hot during use. Allow them to cool before handling.
13. Do not place appliance on any surface while it is operating.
14. While using the appliance, keep your hair out of it. Keep your hair away from the air inlets.
15. Do not use with voltage converter.
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
This appliance is intended for household use only. Use on Alternating Current (60 hertz) only. Standard Dryers are
designed to operate at 110 to 125 volts A.C.
This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fi t in a
polarized outlet only one way. If the plug does not fi t fully in the outlet, reverse the plug. If it still does not fi t,
contact a qualifi ed electrician. Do not attempt to defeat this safety feature.
IMPORTANT –
1875 WATT OPERATING GUIDE
Use of this dryer on the same circuit or fuse with other electrical products or appliances may trip a 15 amp circuit
breaker or blow a 15 amp fuse. NEVER replace the fuse with one rated higher than the capacity of the
circuit. Doing so could result in an electrical fire.
CHECK ALCI SAFETY FEATURE EVERY TIME YOU USE APPLIANCE.
This appliance is equipped with an Appliance Leakage Circuit Interrupter (ALCI), a safety
feature that renders it inoperable under some abnormal conditions, such as immersion in
water. To make sure the ALCI is functioning properly, perform the following test. The
purpose of this test is to allow you to make sure the water sensing system (ALCI) is
working.
1. Plug in the appliance and press test button on plug (See appropriate diagram below).
2. The appliance will stop working. There will be an audible click and reset button will
pop out.
Reset
Test
Reset
Test
06NP086 208 IB.indd 4-506NP086 208 IB.indd 4-5 3/22/06 4:04:39 PM3/22/06 4:04:39 PM