Clarity AL11 Medical Alarms User Manual


 
E
N
G
L
I
S
H
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS
1
2
When using your Clarity AL11, basic safety precautions should
always be followed to reduce the risk of fire, electric shock and
persons including the following:
1. Read and understand all instructions.
2. Follow all warnings and instructions marked on the product.
3. Do not use this product near a bathtub, wash basin, kitchen
sink or laundry tub, in a wet basement, near a swimming pool or
anywhere else there is water.
4. Avoid using a telephone (other than a cordless type) during a
storm. There may be a remote risk of electrical shock from lightning.
5. Do not use a telephone to report a gas leak in the vicinity of the
leak.
6. Unplug this product from the wall outlets before cleaning. Do
not use liquid cleaners or aerosol cleaners on the product. Use a
damp cloth for cleaning.
7. Place this product on a stable surface. Serious damage and/or
injury may result if the product falls.
8. Do not cover the slots and openings on this product. This
product should never be placed near or over a radiator or heat
register. This product should not be placed in a built-in installation
unless proper ventilation is provided.
9. Operate this product using the electrical voltage as stated on the
base unit or the owner’s manual. If you are not sure of the voltage
in your home, consult your dealer or local power company.
10. Do not place anything on the power cord. Install the product
where no one will step or trip on the cord.
11. Do not overload wall outlets or extension cords as this can
increase the risk of fire or electrical shock.
12. Never push any objects through the slots in the product. They
can touch dangerous voltage points or short out parts that could
result in a risk of fire or electrical shock. Never spill liquid of any
kind on the product.
13. To reduce the risk of electrical shock, do not take this product
apart. Opening or removing covers may expose you to dangerous
voltages or other risks. Incorrect reassembly can cause electric
shock when the appliance is subsequently used.
14. Unplug this product from the wall outlets and refer servicing
to the manufacturer under the following conditions:
A. When the power supply cord or plug is frayed or
damaged.
B. If liquid has been spilled into the product.
C. If the product has been exposed to rain or water.
D. If the product does not operate normally by following
the operating instructions. Adjust only those controls
that are covered by the operating instructions. Improper
adjustment may require extensive work by a qualified
technician to restore the telephone to normal
operation.
E. If the product has been dropped or the case has been
damaged.
F. If the product exhibits a distinct change in performance.
15. Never install telephone wiring during a lightning storm.
16. Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
17. Never touch uninsulated telephone wires or terminals unless
the telephone line has been disconnected at the network interface.
18. Use caution when installing or modifying telephone lines.
19. Use only the power cord indicated in this manual.
20. The apparatus shall not be exposed to dripping or splashing and
that no objects filled with liquids, such as vases, shall be placed on
the apparatus.
21. The battery shall not be exposed to excessive heat, such as
sunshine, fire or the like.
22. The MAINS plug is used as the disconnect device, which shall
remain readily operable.