Filter
Top Products
SYSTOLICmmHg
DIASTOLICmmHg
PULSE/min
When diastolic pressure value is detected, the measurement is
complete. Systolic pressure value is displayed on the upper side
and diastolic pressure on the lower side of the display.
Then air in the “wrist cuff” will deflate immediately and the mark
“▼” appears during deflation.
Blood pressure values and pulse rate appear alternatively on the
display every approximately two seconds. Display of the mea-
surement result will continue until power is turned off.
4. Subsequent Measurements
When more than one reading is desired, wait at least two min-
utes between reading in order for the blood at wrist flow to re-
turn to normal. Then press the “START” switch again.
SYSTOLICmmHg
DIASTOLICmmHg
PULSE/min
SYSTOLICmmHg
DIASTOLICmmHg
PULSE/min
5. Turn Power Off
Press the “Power Switch” to turn OFF.
6. Automatic Power Off Function
If this unit is left on after measurement, an Automatic Power-
OFF Function turns the power OFF after approximately 3 min-
utes. To continue measurement press the power switch to turn
the unit ON.
English
- Eng 9 -