Filter
Top Products
- Eng 6 -
BATTERY REPLACEMENT
MEASUREMENT PROCEDURES
1. To use this unit, you must install batteries,
and also If battery mark “
” will display
on the display, you must change two pieces
of batteries.
2. Open battery cover as illustrated.
Replace the new two pieces of batteries,
matching the (+) and (–) polarities on each
battery with the polarity marks on the case.
3. “LR03” batteries or equivalent is suitable for
this blood pressure meter.
1. Attaching of wrist cuff
The blood pressure is measured at the wrist.
Therefore, rolling up the sleeve is no longer
necessary. The pressure cuff has integrated
into the wristlet.
Wind the wristlet around your left wrist. The
wrist should be free. The display is at the in-
ner of the wrist.
• Pull the transparent ribbon to remove the bat-
teries.