Chauvet RGY Wheelchair User Manual


 
Page 16 of 24 Scorpion™ RVM/RGY/GVC User Manual (Rev. 01e)
Laser Sky Mode
To enable the Laser Sky Mode, follow the instructions below:
1) Connect this product to a suitable power outlet.
2) Turn this product on.
3) Press <MENU> repeatedly until one of the following menu options appear on the display:
LS1, LS2, LS3.
4) Press <ENT>.
Never connect a fixture that is operating in Static, Automatic, or Sound mode to a DMX
string that is being controlled by a DMX controller because it may interfere with the
signal from the controller.
Master/Slave Mode
This mode allows a single Scorpion RVM/RGY/GVC unit (the “master”) to control the actions
of one or more Scorpion RVM/RGY/GVC units (the “slaves”) without the need of a DMX
controller. The master unit will be set to operate in either Automatic or Sound mode, while the
slave units will be set to operate in Slave Mode. Once set and connected, the slave units will
operate in unison with the master unit.
Configure the units as indicated below.
Slave units:
1) Press <MENU> repeatedly until SLA shows on the display.
2) Press <ENT> to accept.
3) Connect the DMX input of the first slave unit to the DMX output of the master unit
4) Connect the DMX input of the subsequent slave units to the DMX output of the previous
slave unit.
5) Finish setting and connecting all the slave units.
Master unit:
1) Set the master unit to operate in either Automatic, Laser Sky, or Sound mode, as
previously indicated.
2) Make the master unit the first unit in the DMX daisy chain.
Wait until all the slave units are configured and connected before connecting the
master unit to the DMX daisy chain.
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because it may interfere with the signals from the master unit.
Do not connect more than 31 slave units to the master unit.