Filter
Top Products
5
provided it contains no particles or
abrasive substances. Rinse off all foam and
let the shaver run for a few more seconds.
• Next switch the shaver off and press the
release buttons. Lift the shaver foil off and
pull the cutter block out. Then leave the
disassembled shaving parts to dry.
Alternatively, you may clean the shaver using
the brush provided:
• Switch the shaver off. Press the release
buttons and lift shaver foil off.
• Using the brush, clean the cutter block and
the inner area of the shaver head. However,
do not clean the shaver foil with the brush
as this may damage the foil.
Keeping your shaver in top shape
About every four weeks, clean the cutter block
with Braun cleaning agents. Put a drop of light
machine oil onto the long hair trimmer and the
shaver foil.
Preserving the batteries
In order to maintain the optimum capacity of
the rechargeable batteries, the shaver has to
be fully discharged (through normal use) every
6 months approximately. Then recharge the
shaver to full capacity. Do not expose the
shaver to temperatures higher than 50°C for
extended periods of time.
Replacing the shaving parts
To maintain 100% shaving performance,
replace your foil and cutter block every 18
months or when worn. Change both parts at
the same time for a closer shave with less skin
irritation.
(Shaver foil and cutter block: part no. 4000)
Environmental notice
This appliance is provided with nickel-
cadmium rechargeable batteries.
To protect the environment, do not
dispose of this appliance in the household
waste at the end of its useful life. Disposal
can take place at a Braun Service Centre or
appropriate collection sites.
However, if you prefer to dispose of the
appliance yourself, remove the batteries as
shown on page 29.
Subject to change without notice.
This product conforms to the EMC-
Directive 89/336/EEC and to the Low
Voltage Regulation (73/23 EEC).
Electric specifications see printing on the
special cord set.
Cd
5713452_4775_AMEE_S4-42 Seite 5 Dienstag, 21. Oktober 2003 8:36 08