Filter
Top Products
18
Operating your Clean&Charge
•
Connect your Clean&Charge with the low voltage supply
cord to the mains electricity supply.
•
Open the contact bow (13) by pressing the release
button (14). After shaving, switch the shaver off and
place it upside down into the Clean&Charge (without
having released the shaver foil).
•
Select the operation mode by toggling with the mode
selector (15):
•
«clean» (about 15 min)
•
«clean» + «charge» (about 75 min)
•
«charge» (about 60 min)
•
The corresponding lights will come on.
•
(With cord shavers, only the «clean» function can be
selected.)
•
Slide down the contact bow to connect the shaver and
to start the selected programme.
•
If no programme is selected, the default function «clean»
will be started.
•
Do not interrupt a running programme, as it leaves the
shaver wet and not fit for use. If interruption is needed
nonetheless, press the release button.
•
After a programme has finished, the corresponding light
will go out. Prior to the next shave, press the release
button to release the shaver.
•
When the «cartridge» light starts flashing, the remaining
fluid in the cartridge is sufficient for about 5 more
cleaning cycles. After these 5 cycles, the cleaning
performance will be reduced and the cartridge has to be
replaced.
•
When the «cartridge» light illuminates constantly, the
cleaning function is locked and a new cartridge has to be
installed.
Only then, the next cleaning cycle can be started.
•
A cleaning cartridge should be sufficient for about 30
cleaning cycles. With daily use, the cleaning cartridge
should be replaced approx. every 4 weeks.
•
The hygienic cleaning solution cartridge contains alcohol
which, once opened, will naturally evaporate slowly into
the surrounding air. Each cartridge, if not used daily,
should be replaced after approx. 8 weeks.
•
Clean the housing from time to time with a damp cloth,
especially the opening where the shaver rests.
Subject to change without notice.
a
u
t
o
m
a
t
i
c
l
o
c
k
3
2
1
0
a
u
t
o
m
a
t
i
c
l
o
c
k
3
2
1
0
on/off
clean
ch
arge
c
artridg
e
7630
7630
3
select
select
select
clean
charge
cartrid
g
e
7630
7630
a
u
t
o
m
a
t
i
c
l
3
2
1
0
3
5493464_7630_Korea-4-16 Seite 18 Montag, 6. Januar 2003 8:31 08