Filter
Top Products
7
Description
1. Special cord set
2. «start cleaning» button
3. Station-to-shaver connecting contacts
4. Station lift button for cartridge exchange
5. Display for cleaning programs
6. Display for cleaning fluid status
7. Station socket
8. Cleaning cartridge
9. Shaver foil protection cap
10. Shaver foil
11. Cutter block
12. Foil release buttons
13. Long hair trimmer
14. Shaver-to-station connecting contacts
(shaver backside)
15. Switch
16. Shaver charging lights (green)
17. Shaver low-charge light (red)
18. Pilot light
19. Shaver socket
Before shaving
If you wish, you may start shaving right away (if the shaver
is charged). However, we recommend to follow the
procedure described here:
• Using the special cord set (1), connect the socket of the
Clean&Renew™ station (7) to an electrical outlet.
• Press the station lift button (4) to open the housing.
• Hold the cleaning cartridge (8) down on a flat, stable
surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge into the base of the station as far
as it will go.
• Slowly close the housing by pushing it down until it
locks.
eco
normal
intensive
auto s
el
full
ca
rtridge
empty
2
c
le
a
n
e
c
o
n
o
rm
al
in
te
n
sive
full
cartridge
auto
sele
ct
em
p
ty
1
c
le
a
n
e
c
o
n
o
rm
a
l
in
te
n
s
ive
fu
ll
cartridge
auto select
em
p
ty
c
le
a
n
e
c
o
n
o
rm
a
l
in
te
n
s
iv
e
fu
ll
cartridge
auto select
em
pty
5645300_NA_4-34 Seite 7 Montag, 13. Juni 2005 12:16 12