Filter
Top Products
Page 14
1500
Cycles
750
Cycles
Maintenance and Lubrication Schedule
continued
Perform all procedures listed in previous sections also
Resecure, replace damaged parts or otherwise
correct as needed. Note: Apply Light Grease to
Lift-Tite
™
latch tower pivot point if replacing latch.
Correct or replace damaged parts.
Remove foreign objects, replace damaged parts
and resecure as needed
Correct as needed.
Correct as needed.
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Grease (synthetic) to contact areas be-
tween upper/lower fold arms. See Lubrication
Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Apply Light Oil - See Lubrication Diagram
Correct, replace damaged parts and/or relubri-
cate.
Correct, replace damaged parts and/or relubri-
cate.
Resecure, replace or correct as needed. See
Platform Angle Instructions and Floor Level
Adjustment Instructions.
Replace damaged parts.
Inspect Lift-Tite
™
latches and gas springs for wear
or damage (bent, deformed or misaligned), posi-
tive securement (external snap rings) and proper
operation
Inspect outer barrier for proper operation
Inspect platform fold gear rack and gear weldment
teeth for foreign objects, wear or damage (bent,
deformed or misaligned), positive securement and
proper operation
Inspect lift for wear, damage or any abnormal
condition
Inspect lift for rattles
Outer barrier activation foot pivot bearings (2)
Outer barrier pivot arm bearings (4)
Upper fold arm cam followers (4)
Upper/lower fold arms (2)
Platform pivot pin bearings (4)
Lower fold arm bearings (8)
Inner roll stop lever bearings (2)
Inner roll stop lever slot (2)
Saddle support bearings (8)
Parallel arm pivot pin bearings (16)
Handrail pivot pins (2)
Hydraulic cylinder pivot bushings (8)
Inspect Lift-Tite
™
latch rollers for wear or damage,
positive securement and proper operation (2)
Inspect outboard roll stop feet for proper opera-
tion, positive securement and detached or missing
torsion spring
Inspect inner roll stop for:
• Wear or damage
• Proper operation. Roll stop should just rest on
top surface of the threshold (base) plate.
• Positive securement (both ends)
Inspect handrail components for wear or damage,
and for proper operation