Filter
Top Products
13
Using the OxyJet™ Irrigator
Before using for the first time, fill the water container and
allow the water to run through completely by holding
the irrigator handle over a washbasin.
1. Attach one of the irrigator jets to the handle until it
locks in place. Fill the water container with water and
add mouthwash, if desired.
2. Turn on the irrigator by pressing the blue on/off
switch. (When doing so, the sliding switch on the
handle should not be pushed up.)
3. Select the water pressure with the pressure control
dial (1 = gentle, 5 = strong). We recommend that you
start with setting 1, especially if your gums tend to
bleed or if children are using the irrigator.
4. Bend over the washbasin and guide the jet to your
teeth and gums. Slide the handle switch up to start
the water stream. Keep your mouth slightly open to
allow the water to run into the washbasin.
You can choose between two different jet functions
by sliding the jet switch down or up (before doing so,
turn off the water stream by pushing the sliding switch
down):
Rotating stream
for general cleaning and gum
massa
ge (jet switch in lower position)
The rotation of the water stream and its micro-bubbles
is designed for easy penetration below the gumline.
Mono stream:
straight water stream for site-specific
cleaning ( jet switch in upper position)
Max. operating time: 15 minutes
Cooling off time: 2 hours
4715119_ OC15X_P4-96 Seite 13 Mittwoch, 11. Oktober 2000 7:31 07