Filter
Top Products
9
Switching on
• To start the energy supply, slide
switch (B) up to position «1».
• Then slide it further up to the «start»
position until you can clearly hear a
click. Let the switch move back to
position «1» = on.
• The ignition window (C) lights up
to show that the appliance starts
heating up. In the unlikely case that
it does not heat up, make sure the
energy supply is on and push the
switch (B) to the start position again.
• After approximately 2 minutes, the
ready indicator dot (D) changes
colour. The appliance is now ready
for use.
Straightening
• Make sure your hair is completely dry
before using the appliance.
• First, comb or brush your hair to
remove tangles.
• Section your hair off. Place a strand
(3 - 4 cm width maximum) between
the straightening plates and clamp it
close to the roots. It is easier if you
hold the hair section at an angle
away from your head.
• For straightening, slowly pull the
appliance towards the hair ends with
a continuous movement. Do not rest
on one spot for longer than 2 sec-
onds.
After use
To switch off, slide the energy supply
switch (B) back to position «0» = off.
Cleaning and storage
Make sure the appliance is switched off
and cold. You may clean the appliance
with a soft damp cloth. Never immerse
the appliance in water.
After use or cleaning, always place the
protective cover (A) on the appliance.
It is heat-resistant and ensures that
the appliance is not switched on
unintentionally. You can store away
the appliance (even in a bag) immedi-
ately after usage.
Subject to change without notice.
This product conforms to the
EMC-Directive 89/336/EEC.
When travelling by air, please note that
no more than one appliance may be
carried by each crew member or
passenger aboard an aircraft in checked
luggage, if the protective cover is
secured over the heating element.
Separate gas refills are not permitted.
3591079_MS1_MN_06-48 02.05.2007 14:46 Uhr Seite 9