Filter
Top Products
7
English
Our products are engineered to meet the
highest standards of quality, functionality
and design. We hope you thoroughly
enjoy your new Braun Oral-B appliance.
The Braun Oral-B Plak Control oral
irrigator removes remaining food parti-
cles from between your teeth, while it
also effectively massages your gums.
For this reason, the oral irrigator should
always be used after brushing your teeth.
Prior to using any Braun Oral-B appliance
we recommend that you carefully read
the following use instructions so that
you and your family know how to best
operate the unit safely.
Caution
Check the cord occasionally for any
damage. Should this be the case, unplug
the motor part
2
immediately and take
the appliance to a Braun Service Centre.
A damaged or non-functioning unit may
no longer be used.
Description
1
Water container
2
Motor part
3
Removable compartment for
attachable jets
4
4
Four attachable jets with different
colour markings
5
Water impact control
6
Press button for maximum water
impact in the on/off switch
7
7
On-/off switch
8
Irrigator handle
9
Cord storage
j
Connections for the charging unit of a
plaque remover, Braun Oral-B Plak
Control
k
Wall holder
l
Two screws with wall plugs
Wall holder
Your oral irrigator comes with a wall
holder
k
for the motor part
2
. Use the
enclosed screws and wall plugs
l
to
mount (a). The two grooves
m on the
back of the motor part 2 are pushed
down onto the hooks n of the wall holder
k. The cord storage compartment 9
offers practical storage of the cord. Only
use as much cord as you need to reach
the socket.
Specifications
Voltage: 220–240 Volt (~) ac, 50–60 Hz
Power intake: 20 Watt (therefore also
suitable for shaver sockets)
Max. operatiog time: 20 minutes
Cooling off time: 2 hours
Water capacity: approx. 600 ml
Number of impulses: approx. 500–1000
impulses per minute, continuously
adjustable
Switch
Turn on the oral irrigator by pushing the
on/off switch 7 up. Turn it off by sliding
the on/off switch back to its initial
position (i.e. below the arrow).
The water impact control 5 regulates the
impulse pressure: gentle = 2, strong = 8.
The water impact is continuously variable
and electronically controlled. You may
press the button 6 in the on/off switch 7
to obtain maximum water impact, inde-
pendent of the impact shown (2–8).
By this, even the most resistant food
particles can be removed from between
the teeth.
Getting started
After connecting the unit to a socket,
remove water container 1 and fill with
lukewarm water. Then place the water
container firmly onto the unit (c). Before
using for the first time, allow the water to
run through completely. Take the handle
4714058_MD9_S.4-30.fm Seite 7 Freitag, 3. Mai 2002 11:09 11