Braun HD 730 Hair Dryer User Manual


 
6
English
Carefully read the use instructions before use.
Important
• Plug your hairdryer into an alternating current (Ƃ) outlet
only and be sure that your household voltage corresponds
to the voltage marked on the hairdryer.
This appliance must never be used near water
(e.g. a filled wash basin, bathtub or shower). Do not
allow the appliance to become wet.
• When using the hairdryer in a bathroom, always unplug it
after use. Even a switched-off hairdryer presents a hazard
if not unplugged.
• For additional protection, it is advisable to install a residual
current device (RCD) with a rated residual operating
current not exceeding 30 mA in the electrical circuit of
your bathroom. Ask your installer for advice.
• Care should be taken not to block the inlet and outlet grill
when the hairdryer is switched on.
• If either grill becomes blocked, the hairdryer will automati-
cally cut out. After cooling for a few minutes, it will switch
back on automatically.
• Do not wrap the mains cord around the appliance.
• Regularly check the mains cord for wear or damage,
particularly where it enters the product and the plug. If you
have any doubt about its condition take the appliance to
your nearest Braun Service Centre for checking/repair. The
mains cord of the appliance may only be replaced by an
authorised Braun Service Centre. Unqualified repair work
can lead to extreme hazards for the user.
• This appliance is not intended for use by children or
persons with reduced physical or mental capabilities,
unless they are given supervision by a person responsible
for their safety. In general, we recommend that you keep
the appliance out of reach of children.
Description
1 Switch
2 «satin protect™» button with light
3 Cold shot button
4 Protection filter
5 Ion switch with light
6 Concentrator nozzle
7 Diffusor attachment
Switch (1)
Two airflow and three temperature settings allow you to
personalize your hairdryer for a fast and efficient, but also
gentle drying.
Airflow Temperature
II high high III
I low medium II
O off low I
«satin protect™» Drying
By sliding up the «satin protect» button (2), you can reduce
the temperature setting, thus increasing the variety of
settings. «satin protect» makes drying even gentler by
avoiding high temperatures. This protects the hair texture.
The «satin protect» light shines when this function is
activated (a).
IONTEC
IONTEC is a technology which is specifically developed to
protect the health of your hair. It restores the moisture
balance of your hair that usually gets lost during styling with
excessive heat.
95679885_HD730_China.indd 695679885_HD730_China.indd 6 21.12.10 10:2221.12.10 10:22