Filter
Top Products
7
English
Our products are designed to meet the highest standards of quality,
functionality and design. We hope you enjoy your new Braun appliance.
Warning
• Keep the appliance dry.
• Do not wind the cord around the appliance.
• For safety reasons, periodically check the cord for damage and replace it
if necessary.
Description
Technical specifications
Power supply: 100 – 240 V 2 / 50 or 60 Hz
(automatic adaptation)
Wattage: 5
Charging your beard trimmer for cordless operation
• Connect the trimmer to the mains with the on/off switch on position «0»
and charge it for at least 8 hours. The pilot light indicates that the trimmer
is connected to the mains.
• Once the trimmer is completely charged, use it without the cord until
discharged.
• Then recharge to full capacity again (subsequent charges will take about
8 hours).
• A full charge will give up to 30 minutes of cordless trimming depending
on your beard. However, the maximum capacity will only be reached after
several charging/discharging cycles.
• Best environmental temperature range for charging is 15°C to 35°C.
• If the rechargeable battery is discharged, you may also operate the
trimmer via the mains cord. (If the trimmer does not run immediately,
charge it for approx. 1 minute.)
1a Small distance comb (trimming
beard and short hair)
1b Large distance comb (cutting hair)
2 Cutter system
a beard trimming/hair trimming
b release buttons
3 Speed selector
4 On/off switch
with beard length selector
5 Memory switch
(for 6 beard length settings)
6 Pilot light
5601157_EP50_MN Seite 7 Donnerstag, 13. Januar 2005 3:27 15