Filter
Top Products
10
water (e.g. a filled wash basin,
bathtub or shower).
• Keep the appliance out of the
reach of children.
• Before use, check whether your
voltage corresponds to the volt-
age printed on the transformer.
Always use the 12 V transformer,
type PI-41-77 V-3.
Description
(see page 4)
Ö
Soothing attachment
Ü
Tweezer grip selector
á
Epilator head with
tweezer element
à
Release bar for epilator head
â
Switch
ä
Socket
ã
Cord connector
å
12 V transformer with plug
for power socket
Underarm and bikini line epilation
Use tests monitored by dermatol-
ogists have shown that the epilator
head may as well be used underarm
and at the bikini line. Be aware that
these areas are particularly sensitive
to pain. However, the pain sensation
will diminish with repeated usage.
For this specific application, we
would like to give the following
advice:
• Before epilating, thoroughly clean
the respective area to remove
residue (like deodorant).
Then dry carefully with a towel
using a dabbing action to avoid
skin irritation.
• Hair should not be longer than
5 mm.
• After use, apply Silk·épil cream or
baby powder (don’t use alcoholic
deodorants).
How to operate your Silk·épil
Before starting off, make sure that
the epilator head is thoroughly
cleaned and disinfected. Your skin
must be dry and free from grease
or cream.
• Plug the cord connector into the
socket and plug the transformer
into an electrical outlet.
1
Select the tweezer grip:
+ full tweezer grip
for normal to thicker hair
– reduced tweezer grip
for finer hair
• Switchin
g on
0 = Off
1 = For gentle epilation
2 = For normal epilation
3 = For high-speed epilation
2
Rub your skin to lift short hairs.
Apply the Silk·épil at right angles
(90°) against your skin. For best
epilation results, make sure that
the soothing attachment wheels
always
keep in contact with the
skin surface. Pressing gently,
guide it
slowly against the hair
growth. Underarm this means
guiding the appliance in different
directions. Do not press too hard.
On bony parts, we recommend
to use a lower switch setting.
5303XXX_EE1170_P6-76 Seite 10 Freitag, 28. November 2003 9:27 09