Filter
Top Products
9
1 Description
A Energy supply / start switch
«0» = off,
«1» = energy supply,
«start» = starting heat up
B Ready indicator dot
C Ignition control window
D Tong
E «open» release button for handle
F Round styling brush
G Protective heat resistant cover with safety lock
Before use
2 Inserting or changing the Braun
«energy cell»
The energy supply must be switched off (switch (A)
at position «0»).
Press the «open» release button (E) and pull off the
handle.
Insert a Braun energy cell into the handle as shown
in the illustration (arrows on energy cell pointing
outward). Push the handle with the energy cell
back onto the appliance until it snaps into place.
The energy level in the cell can be checked
through the window at the bottom of the
appliance.
Only use Braun energy cells. These are available
from the store where this appliance was pur-
chased, as well as from authorised Braun Service
Agents. The energy cells can be taken out or
changed at any time, even if they are only partly
filled.
3 Switching on
a) To start the energy supply shift switch (A) up to
position «1» (the protective cover (G) must be
removed).
b) Wait 3 to 4 seconds.
c) Shift switch (A) further up to the «start» position
until you can clearly hear a click.
This starts heating up the appliance.
d) Let the switch slide back to position «1».
e) Red dots shining in the ignition control window
indicate that the styler has ignited and is heating
up. In the unlikely case that it does not heat up,
make sure that the gas is on and push the start
switch again.
f) After approx. 1 to 2 minutes, the ready indicator
dot (B) turns dark. Only then is the Braun
Cordless heated up to the optimum styling
temperature and ready for use.
4 Styling
Braun Cordless offers various styling functions:
a) The tong (D) is ideal to create all different kinds
of curls, but also to smoothen and straighten
small sections of your hair.
b) With the round styling brush attachment (F) you
can create soft waves, choppy styles, flicks and
curl the hair ends under.
5 After use
The brush attachment (F) can be put on and off as
shown.
3589391_C20_MN Seite 9 Mittwoch, 24. Mai 2006 4:09 16