Filter
Top Products
26
Shaving
If the shaver is locked into the Clean&Charge station,
push the «start cleaning» button (2) to release the shaver
and take it out.
Switch positions
0 = Off (switch is locked)
Press and push up the switch to operate the shaver:
1 = Shaving with the pivoting head
The pivoting cutting system automatically adjusts to
every contour of your face.
2 = Shaving with the pivoting head locked at an angle (to
permit shaving in difficult areas, e.g. under the nose).
3 = The long hair trimmer is activated (for trimming
sideburns, moustache and beard).
Tips for the perfect shave
We recommend that you shave before washing, as the
skin tends to be slightly swollen after washing.
Hold the shaver at right angles (90°) to the skin.
Stretch your skin and shave against the direction of beard
growth.
To ensure optimal shaving performance, replace the
shaver foil and cutter block when it is indicated on the
shaver display or when the parts are worn or at least every
18 months.
Shaving with the cord
If the shaver is completely discharged and you do not
have the time to recharge in the Clean&Charge station,
you may also shave with the shaver connected to the
mains via the special cord set.
After shaving
Automatic cleaning
After each shave, return the shaver to the Clean&Charge
station and proceed as described above in the section
«Before shaving». All charging and cleaning needs are
then taken care of. With daily use, a cleaning cartridge
should be sufficient for about 30 cleaning cycles.
The hygienic cleaning solution cartridge contains alcohol
which, once opened, will naturally evaporate slowly into
the surrounding air. Each cartridge, if not used daily,
should be replaced after approximately 8 weeks.
2
1
2
1
3
2
1
8795
full
cartridge
a
u
to
se
le
c
t
em
pty
s
t
a
r
t
c
l
e
a
n
i
n
g
ec
o
n
o
rm
a
l
in
te
n
s
iv
e
clea
n
3
2
1
off
Activator_8795_Japan Seite 26 Dienstag, 14. Dezember 2004 4:00 16