Filter
Top Products
8
Upper (systolic) value
Lower (diastolic) value
Pulse
Important
15 seconds after switching on the device the
measuring process will begin automatically, even if
the appropriate measuring position has not been
reached.
If at any time you want to discontinue the
measurement, press the I/0 button.
Memory
(only for model BP 2510 with memory button)
The readings of the last 20 measurements will be
saved automatically.
To recall the latest stored reading, press the memory
button. Repeatedly pressing the memory button will
call up one by one all stored readings. The number in
the upper left corner of the display gives the memory
position (01 being the oldest, 19 the most recent).
De-activating the active positioning
system
At the time of manufacture, the position sensor has
been activated. If you wish, you can de-activate the
positioning system.
The necessary select button (D) is placed underneath
the battery compartment cover.
First turn off the monitor, then press the select button
until an acoustic signal sounds. On the display the
«on» next to the symbol of the position sensor « »
will flash.
By pressing the I/0 button, you de-activate the
positioning system.
1 / min
mmHg
mmHg
SYS
DIA
Puls
beep
6054008_BP2510_S4-30 Seite 8 Mittwoch, 11. Juli 2001 8:35 08