Braun 8975 Electric Shaver User Manual


 
8
Our products are designed to meet the highest standards
of quality, functionality and design. We hope you enjoy
your new Braun shaver.
The system tells you when to replace the shaving foil and
cutter block.
Warning
Keep the appliance dry. Your shaver is provided with a
special cord set with integrated Safety Extra Low Voltage
power supply. Do not exchange or manipulate any part of
it. Otherwise there is a risk of electric shock.
Description
1 Foil protection cap
2 Shaver foil
3 Cutter block
4 Release buttons
5 Long hair trimmer
6 Switch
7 Charging lights (green)
8 Low charge light (red)
9 Replacement light for shaving parts
10 Reset button
11 Pilot light
12 Shaver socket
13 Special cord set
Charging the shaver
When charging for the first time: Using the special cord
set, connect the shaver to an electrical outlet.
The shaver must be switched off. Charge it for at least
4 hours (special cord set and shaver might get warm).
Once the shaver is completely charged, shave until
fully discharged. Then recharge to full capacity again
(1 hour).
A full charge will give up to 50 minutes of cordless
shaving time, depending on your beard growth.
However, the maximum battery capacity will only be
reached after several charging/discharging cycles.
Best environmental temperature range for charging is
from 15 °C to 35 °C.
When fully discharged, you may also shave with the
shaver connected to an electrical outlet via the special
cord set.
8975
English
5647453_8975_70_S4-74 Seite 8 Dienstag, 7. März 2006 12:27 12