Filter
Top Products
Page 6
Lift Operation Safety
Lift Operation Safety Precautions (continued)
Load and unload clear of vehicular traffic.
Do not overload or abuse. The load rating applies to both the raising and lowering func-
tions - continuous lifting capacity is 750 lbs.
Do not operate or board the lift if you or your lift operator are intoxicated.
Do not raise front wheelchair wheels (pull wheelie) when loading (boarding) the platform.
Open lift door(s) fully and secure before operating lift.
Position and secure (buckle, engage, fasten, etc.) the wheelchair-equipped occupant seat
belt (torso restraint) before loading onto the wheelchair lift platform.
Fold manual-fold handrails down before stowing lift.
Lift occupant must keep hands, arms and all other body parts within the lift occupant area
and clear of moving parts.
Platform must be positioned at floor level when loading or unloading in and out of vehicle.
Do not use the outboard roll stop as a barrier (brake). Stop and brake wheelchair when
fully loaded on the platform (manually stop and brake manual wheelchairs — stop powered
wheelchairs with the wheelchair controls).
Turn powered (electric) wheelchairs off when on lift platform.
Press the DOWN switch until the entire platform rests on ground level (lowered fully) and
the outboard roll stop is fully unfolded (ramp position) before loading or unloading a pas-
senger at ground level.
Outboard platform roll stop must be fully unfolded (ramp position) before front and rear
wheelchair wheels cross roll stop when loading or unloading at ground level.
Accidental activation of control switch(es) may cause unintended operation(s).
After manually releasing platform, stow platform and push manual release T-handle in fully
and move platform in and out to engage platform lock before driving vehicle. Failure to lock
platform may result in unintended platform deployment.
Insert manual release T-handle fully before manually lowering or raising platform and
manually move platform in and out to engage platform lock.
Maintenance and lubrication procedures must be performed by authorized (certified)
service personnel.
Replace missing, worn or illegible decals.
Keep owner’s manual in lift vehicle at all times.
Never modify (alter) a Braun Corporation lift.
Do not use accessory devices not authorized by The Braun Corporation.
Do not remove any guards or covers.
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING
W
A
RNING