Filter
Top Products
25
Shaver
Foil & Cutter cassette
Cassette release button
Shaver head «lock» switch
Pop-out long hair trimmer
On/off switch
(–) setting button (sensitive)
(+) setting button (intensive)
Reset button
Shaver display
Shaver-to-station contacts
Shaver power socket
Travel case
Special cord set
Before shaving
Prior to fi rst use you must connect the shaver to
an electrical outlet using the special cord set
or alternatively proceed as below.
Installing the Clean&Renew station
• Using the special cord set , connect the
station power socket to an electrical outlet.
• Press the lift button to open the housing.
• Hold the cleaning cartridge down on a fl at,
stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
• Slide the cartridge into the base of the station
as far as it will go.
• Slowly close the housing by pushing it down
until it locks.
The cleaning fl uid display
will show how much
fl uid is in the cartridge:
up to 30 cleaning cycles available
up to 7 cleaning cycles remaining
new cartridge required
Charging and cleaning the shaver
Insert the shaver head down into the cleaning
station. (The contacts on the back of the
shaver will align with the contacts in the
cleaning station).
If required, the Clean&Renew station will auto-
matically charge the shaver. The hygiene status
of the shaver will also be analyzed and one of
the following cleaning program indicators will
light up:
new
f
a
s
t
c
l
e
a
n
f
a
s
t
c
l
e
a
n
f
a
s
t
c
l
e
a
n
2
1
t
rim
m
er
S
e
r
i
e
s
7