Filter
Top Products
17
Before discarding the used
cartridge, make
sure to close the openings using the lid of
the new cartridge, since the used cartridge
will contain contaminated cleaning solution.
C Operating your Clean&Renew™
•
Connect your Clean&Renew™ with the low
voltage supply cord to the mains electricity
supply.
Open the contact bow (2) by pressing the
release button (3). After shaving, switch the
shaver off and place it upside down into the
Clean&Renew™ (without having released
the shaver foil).
•
Select the operation mode by toggling with
the mode selector (4):
«clean» (about 15 min)
«clean» + «charge» (about 75 min)
«charge» (about 60 min)
The corresponding lights will come on.
(With cord shavers, only the «clean» function
can be selected.)
•
Slide down the contact bow to connect the
shaver and to start the selected programme.
If no programme is selected, the default
function «clean» will be started.
•
Do not interrupt a running programme,
as it leaves the shaver wet and not fit for use.
If interruption is needed nonetheless, press
the release button.
•
After a programme has finished, the corre-
sponding light will go out. Prior to the next
shave, press the release button to release
the shaver.
•
When the «cartridge» light starts flashing,
the remaining fluid in the cartridge is
sufficient for about 5 more cleaning cycles.
After these 5 cycles, the cleaning
performance will be reduced and the
cartridge has to be replaced.
•
When the «cartridge» light illuminates
constantly, the cleaning function is locked
and a new cartridge has to be installed.
Only then, the next cleaning cycle can be
started.
•
A cleaning cartridge should be sufficient
for about 30 cleaning cycles. With daily use,
the cleaning cartridge should be replaced
approx. every 4 weeks.
•
The hygienic cleaning solution cartridge
contains alcohol which, once opened, will
naturally evaporate slowly into the surround-
ing air. Each cartridge, if not used daily,
should be replaced after approx. 8 weeks.
•
Clean the housing from time to time with a
damp cloth, especially the opening where
the shaver rests.
Subject to change without notice.
This product conforms to the European
Directives EMC 89/336/EEC and Low
Voltage 73/23/EEC.
For electric specifications, see printing on
the special cord set.
Please do not dispose of the product
in the household waste at the end of
its useful life. Disposal can take place
at a Braun Service Centre or at appropriate
collection points provided in your country.
5492447_7790_Korea Seite 17 Freitag, 22. Juni 2007 8:51 08