Filter
Top Products
16
Braun Clean&Renew™ has been developed
for cleaning, charging and storing your
shaver. Clean your shaver daily in the
Clean&Renew™.
During the automated cleaning process,
the shaver is switched on and off at intervals
to obtain best cleaning results. Since the
specially formulated cleaning fluid contains
a small amount of oil, the cleaning procedure
also fulfills the lubrication needs of the
shaver.
Important
•
Only use the low voltage adaptation system
supplied with the shaver.
•
In order to avoid any leakage of the cleaning
fluid, place the appliance on a flat, stable
surface or use the wall holder (not included
in all versions). Do not tip, move suddenly
or transport in any way if a cleaning cartridge
is installed.
•
Do not place the appliance in a mirror cabi-
net, nor store it over radiators, nor place it
on polished or laquered surfaces. Do not
expose to direct sunlight.
•
The appliance contains highly
flammable liquid. Keep it away from
sources of ignition. No smoking.
Keep out of reach of children. Do not refill
cartridge. Use only original Braun refill
cartridge.
•
When cleaning the shaver, its protection
cap should be removed.
A Description
1 Lift button for cartridge exchange
2 Contact bow
3 Release button
4 Operation mode selector
5 «clean» light:
cleaning process indicator
6 «charge» light:
charging process indicator
7 «cartridge» light:
cartridge replacement indicator
8 Cleaning cartridge
Wall holder (not included in all versions)
Mount the wall holder with plugs and screws
to a smooth wall so that the standing surface
for the Clean&Renew™ is horizontal.
Technical specifications
•
Power consumption:
3 W when cleaning
7 W when charging
•
Power supply: 100-240 V
2
/50 or 60 Hz
(automatic adaptation)
•
Input voltage: 12 V
B Before using Clean&Renew™
Only applies for cordless shavers:
For the first charge of the shaver, connect
the low voltage supply cord directly to the
shaver, charge it for 4 hours and shave at
least once.
Only then can the shaver be cleaned or
recharged in the Clean&Renew™.
If the rechargeable battery is discharged,
select the combined «clean» + «charge»
programme rather than the «clean»
programme alone.
Installing the cartridge
•
Press the lift button (1) to open the housing.
•
Hold the cartridge down on a flat, stable
surface (e.g. table). Carefully remove the lid
from the cartridge. Slide the cartridge into
the base as far as it will go.
•
Slowly close the housing by pushing it down
until it locks.
Replacing the cartridge
After having pressed the lift button to open
the housing, wait for a few seconds before
removing the used cartridge.
5492447_7790_Korea Seite 16 Freitag, 22. Juni 2007 8:51 08