Braun 7640 Electric Shaver User Manual


 
35
Clean&Charge
Braun Clean&Charge has been developed
for cleaning, charging and storing your
shaver. Clean your shaver daily in the
Clean&Charge.
During the automated cleaning process,
the shaver is switched on and off at
intervals to obtain best cleaning results.
Since the specially formulated cleaning fluid
contains a small amount of oil, the cleaning
procedure also fulfills the lubrication needs
of the shaver.
Important
Only use the power supply cord set
supplied with the shaver.
In order to avoid any leakage of the cleaning
fluid, place the appliance on a flat, stable
surface. Do not tip, move suddenly
or transport in any way if a cleaning
cartridge is installed.
Do not place the appliance in a mirror
cabinet, nor store it over radiators, nor
place it on polished or laquered surfaces.
Do not expose to direct sunlight.
The appliance contains highly
flammable liquid. Keep it away
from sources of ignition.
No smoking. Keep out of reach of children.
Do not leave cartridge open. Do not refill
cartridge. Use only original Braun refill
cartridge.
A Description
1 Lift button for cartridge exchange
2 Contact bow
3 Release button
4 Operation mode selector
5 «clean» light: cleaning process indicator
6 «charge» light:
charging process indicator
7 «cartridge» light:
cartridge replacement indicator
8 Cleaning cartridge
9 Socket
10 Ventilation
Technical specifications
Power consumption:
3 W when cleaning
7 W when charging
Power supply: 100-240 V
2
/50 or 60 Hz
(automatic adaptation)
Input voltage: 12 V
B Before using Clean&Charge
Only applies for cordless shavers:
For the first charge of the shaver, connect
the power supply cord set directly to the
shaver, charge it for 4 hours and shave at
least once.
Only then can the shaver be cleaned or
recharged in the Braun Clean&Charge.
If the rechargeable battery is discharged,
select the combined «clean» + «charge»
programme rather than the «clean»
programme alone.
Installing the cartridge
Press the lift button (1) to open the housing.
Hold the cartridge down on a flat, stable
surface (e.g. table). Carefully remove the lid
from the cartridge. Slide the cartridge into
the base as far as it will go.
Slowly close the housing by pushing it
down until it locks.
Replacing the cartridge
After having pressed the lift button to open
the housing, wait for a few seconds before
removing the used cartridge.
Before discharging the used cartridge,
make sure to close the openings using the
lid of the new cartridge, since the used
cartridge will contain contaminated
cleaning solution.
5492463_Syncro7497 Seite 35 Donnerstag, 8. Mai 2003 10:14 10